New Member
05-17-2010, 12:18 PM
#1
Heel & Toe
Thread Starter
Member Since: May 2010
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
New Member
Hi ! I am new to this forum from Connecticut but I am hopeful that I can finally get on the stick and finish it. I originally bought it sight unseen three years ago . It didn't look too bad when I purchased it but the brakes with a disaster, the interior was trashed and the floors were gone. I was able to get used floors from a doner car in NC where my son lives. It now runs strong but the interior is in a big hurt. Does someone possibly have some photo's they could share on redoing the interior and the proper sequence ? If I could get by doing this I could at least drive this to see if I have other issues. Thanks for any assistance. Toms76
05-17-2010, 12:23 PM
#2
Safety Car
Welcome to the forum
. You're better off asking your question in the C3 section. Try searching around. There have been plenty of people here who have gone through their complete interiors. I have a '74 that I'll be redoing the interior on pretty soon. Good luck
.
. You're better off asking your question in the C3 section. Try searching around. There have been plenty of people here who have gone through their complete interiors. I have a '74 that I'll be redoing the interior on pretty soon. Good luck.
05-17-2010, 07:07 PM
#8
Race Director
Welcome to the Forum Tom The best place to get the information you need would be C3 general http://forums.corvetteforum.com/c3-general-119/. I know those guys can give you any kind help you need. Good luck
The best place to get the information you need would be C3 general http://forums.corvetteforum.com/c3-general-119/. I know those guys can give you any kind help you need. Good luck
05-17-2010, 08:35 PM
#12
Safety Car
Hello and welcome to the Forum from NE Ohio. 
