North Jersey machine shop for diff bracket
Thread Starter
Melting Slicks
Joined: Jan 2006
Posts: 3,028
Likes: 2
From: North NJ
North Jersey machine shop for diff bracket
Anyone know of a machine shop in north jersey that can make a custom aluminum plate to mount my differential in my C3? Winter project.
Should be fairly simple square plate with center cutout to sandwhich between my pumpkin and rear cover. Would need recessed holes drilled to screw into pumpkin.
Looking for good craftsmanship at a reasonable cost.
Thanks
Should be fairly simple square plate with center cutout to sandwhich between my pumpkin and rear cover. Would need recessed holes drilled to screw into pumpkin.
Looking for good craftsmanship at a reasonable cost.
Thanks
Le Mans Master
Joined: May 2005
Posts: 6,366
Likes: 249
From: Fort Lauderdale, Florida
In the Ledgewood area near where Rt. 46 crosses with I-80, off the westbound side, at the jughandle before Cliff's ice cream is a machine shop named Kenvil Weldery. The owner is Gery Magura. I haven't seen him in several years but when I was building my street rod he helped me with special projects several times. He is a master machinist and can make anything, and perfectly, too! He even has equipment to travel with TIG welding equipment. He might remember working on my '37 Chevy. You will not find anyone better.
Thread Starter
Melting Slicks
Joined: Jan 2006
Posts: 3,028
Likes: 2
From: North NJ
In the Ledgewood area near where Rt. 46 crosses with I-80, off the westbound side, at the jughandle before Cliff's ice cream is a machine shop named Kenvil Weldery. The owner is Gery Magura. I haven't seen him in several years but when I was building my street rod he helped me with special projects several times. He is a master machinist and can make anything, and perfectly, too! He even has equipment to travel with TIG welding equipment. He might remember working on my '37 Chevy. You will not find anyone better.
, that is within a few miles of my work. I'll have to check him out next week.
