***Post your RunFiles_here***
Thread Starter
Melting Slicks
Joined: Jun 2002
Posts: 3,060
Likes: 3
From: Dublin CA
***Post your RunFiles_here***
For diagnostic purposes of mods performed, I'd like to begin comparing curves of various motor configurations.
The Dynojet reader (Demo version) can be found here:
http://www.dynojet.com/downloads/software.shtml
http://www.dynojet.com/downloads/zip/7035_demo.zip
This reads RunFile_000.drf files, and lets you zoom in or open multiple files for comparison. Not all tuners give you the dyno run file. Many of them had you a printout instead, so you won't have a runfile.
Please post a hyperlink to your RunFile, and an outline of the motor configuration.
The Dynojet reader (Demo version) can be found here:
http://www.dynojet.com/downloads/software.shtml
http://www.dynojet.com/downloads/zip/7035_demo.zip
This reads RunFile_000.drf files, and lets you zoom in or open multiple files for comparison. Not all tuners give you the dyno run file. Many of them had you a printout instead, so you won't have a runfile.
Please post a hyperlink to your RunFile, and an outline of the motor configuration.
Thread Starter
Melting Slicks
Joined: Jun 2002
Posts: 3,060
Likes: 3
From: Dublin CA
RunFile_311.drf
_______________________
347CID
8.65:1
Forged pistons and rods
Stage 2 blower heads
Stage 2 blower cam
D1SC, 3" pulley, FMIC
A4, FLP Level 5, 3000 stall
_______________________
347CID
8.65:1
Forged pistons and rods
Stage 2 blower heads
Stage 2 blower cam
D1SC, 3" pulley, FMIC
A4, FLP Level 5, 3000 stall
