Garage floors
#2
Drifting
Just installed Race Deck 400 square feet in about 2 hours.
#3
Drifting
I'd also reccomend RaceDeck - I did my 1100 sq ft garage in a few days.
Here is my full review on my install:
Here is my full review on my install:
Last edited by bonecrrusher; 03-17-2017 at 11:09 PM.
#4
Race Director
Member Since: Jul 2008
Location: The Sunshine State
Posts: 16,999
Received 2,681 Likes
on
1,482 Posts
2022 C5 of the Year Finalist - Modified
2021 C5 of the Year Finalist - Modified
C7 of the Year - Modified Finalist 2021
Finalist 2020 C7 of the Year -- Modified
2020 C5 of the Year Finalist - Modified
C5 of Year Finalist (appearance mods) 2019
2018 C5 of Year Finalist
It really depends on the what you need and intend for the space. If you're a hard core mechanic-type who works on the cars, has four-post lifts, etc., probably the best choice is a professionally prepped and installed textured epoxy.
However, I'm more of a modder and my garage serves duty as a home gym and project area. Plus since I live in Florida, I usually pull in wet cars from the summer afternoon showers, so that's why I chose Racedeck Freeflow tiles. Functional and they look great.
However, I'm more of a modder and my garage serves duty as a home gym and project area. Plus since I live in Florida, I usually pull in wet cars from the summer afternoon showers, so that's why I chose Racedeck Freeflow tiles. Functional and they look great.
The following users liked this post:
J.J.D.O. (06-15-2017)
#5
Pro
Thread Starter
Member Since: Oct 2004
Location: Connelly Springs NC
Posts: 736
Likes: 0
Received 31 Likes
on
21 Posts
Thanks to all
I like to work on cars and hope to start a project in the near future. I think I will do the epoxy since I do not want fluids to go under the tiles.
Hope to have it installed within a month or 2.
Greg G
I like to work on cars and hope to start a project in the near future. I think I will do the epoxy since I do not want fluids to go under the tiles.
Hope to have it installed within a month or 2.
Greg G
Last edited by Greg G; 04-03-2017 at 03:20 PM.
#6
I started to go the epoxy route and do it myself, but since mine had been sealed, I kept worrying about prepping it well enough (might have been going overboard).
Ended updoing the interlocking plastic tile like those above. Got them from Speedway Tile in Cleveland, Tn. Came out to a dollar and change per sq foot.
Prep was just vacuum and mop, then put down some landscape fabric. Laying the tile was a cakewalk, just snap into place.
With the epoxy just make sure they do good prep and offer a warranty. Quality work and it will be a great surface.