C8 Corvette / C8 Stingray/General Discussion Today 06:29 PM
What has been said is true, however ... be advised that the VHB tape used by GM on these wings is super, super, super strong, and does NOT come apart without a most serious fight! Many .. including...
New Member / Intros Today 06:28 PM
Welcome, good hunting for C7 ZR1 only made 1 year, and they don't sell cheap, you need a big pockets.
Italfra#1
Thread Starter
C8 Corvette / C8 Stingray/General Discussion Today 06:27 PM
I was thinking that maybe there would have been a couple posts today on the 27's rolling down the assembly line? I'm holding steady at 3300 and hopefully with tomorrow's update from MM I'll be even...
C6 Corvette, 2005 - 2013 / C6 Corvette ZR1 & Z06 Today 06:27 PM
djfury05
You could always look into aftermarket castings which are superior anyways. Probably more money but you'll have no valve drop worries. Brodix, Trickflow, PRC, Frankenstein, Mast Motorsports etc. And...
Railroadman
Thread Starter
C1 & C2 Corvettes, 1953 - 1967 / C1 & C2 Corvettes Today 06:26 PM
Too busy to give an account of each nut and bolt, but the balancer is on. WHAT a difference that installation tool makes! Radiator is set in but not secured, etc. I'm hoping to test-fire it up...
C8 Corvette / C8 Stingray/General Discussion Today 06:26 PM
I don't know how the paint lives at the body joints where is it is bolted together.
I expect to see that on my 23, I have had the rear bumper off several times, no problems yet.
Phobos84
Thread Starter
C4 Corvettes, 1984 - 1996 / C4 Tech/Performance Today 06:25 PM
dizwiz24
there was a welding shop in youngstown that filled my bottles cheap. Back in 2004 timeframe was $35 for a 10 lb bottle (Summit was around $50-55 then)
last time ingot it filled there was 2021
...
vettepoor
Thread Starter
C1 & C2 Corvettes, 1953 - 1967 / C1 & C2 Corvettes Today 06:25 PM
I know this has been discussed here on the forum many times. I recently found a dead mouse on the floor of my 57. Sucker was still limp, so I assumed it died shortly before I found it. I drive my...
C3 Corvettes, 1968 - 1982 / C3 General Today 06:24 PM
majorbob
I freely admit, not sure what I am looking at, but am guessing the one on the left should look just like the one on the right.