Help! Code B0338 and B0441
#1
Instructor
Thread Starter
Help! Code B0338 and B0441
I have just replaced both of my HVAC door actuators. I am getting Code B0338 and B0441. There is a two wire connector near the drivers side actuator that I cannot find where to plug in. the other end is near the ignition switch, but I can't find where to plug that in either.
Anyone know how to fix this issue?
Any help would be greatly appreciated. Pictures very well desired.
Thanks
Anyone know how to fix this issue?
Any help would be greatly appreciated. Pictures very well desired.
Thanks
Last edited by GEMcLean; 07-23-2020 at 10:53 AM.
#3
Burning Brakes
There is only one 5 pin connector for the actuator ( feedbackpotmeter and motor supply).
B0338 Inside Air Temp Sensor Open- Did you disconnected this sensor close to the ignition key ? Your wire and 2 pin connector is probably for this sensor
B0441 Left Actuator Out of Range - Have you tried to index your actuators ( Fuse disconnected for tha HVAC control min 60 sec ) ?
B0338 Inside Air Temp Sensor Open- Did you disconnected this sensor close to the ignition key ? Your wire and 2 pin connector is probably for this sensor
B0441 Left Actuator Out of Range - Have you tried to index your actuators ( Fuse disconnected for tha HVAC control min 60 sec ) ?