eDead Door Install Question
Thread Starter
Instructor
Joined: Oct 2005
Posts: 177
Likes: 0
From: Charleston SC
eDead Door Install Question
I just finished installing the eDead on the inner doors of my Z06 (still need to roller it though). My question is do I need to do the areas at the top and bottom of the door or just get the large flat areas of the door skin?
I have attached 2 pictures and welcome any feedback as this is the first time I have done this. The first shows the flat bottom of the door and the second shows the top near the slot for the window.
I have attached 2 pictures and welcome any feedback as this is the first time I have done this. The first shows the flat bottom of the door and the second shows the top near the slot for the window.
Team Owner
Joined: Feb 2000
Posts: 51,504
Likes: 6
From: Sacramento CA
Tap the panel, and put your finger about 8" from where you are tapping. The places where you feel the vibration in your other hand are the places you should concentrate on.
I didnt bother deadening the parts you mentioned. I put a LOT behind the DCM, and on the other side of the panel, too.
I didnt bother deadening the parts you mentioned. I put a LOT behind the DCM, and on the other side of the panel, too.
