radio electrical problem
#1
Navigator
Thread Starter
Member Since: Sep 2011
Location: Millen GA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
radio electrical problem
If my 2005 c6 sits for several days the radio produces no sound. The station reads out and sound bar moves up and down, but no sound. I have to disconect the battery to get it to reset. Anyone have an answer?
Last edited by plm45; 09-27-2011 at 07:00 AM. Reason: spelling
#3
Tech Contributor
Loose/broken trigger wire to the amp is my guess, but you'd have to check it with a meter WHILE IT WASN"T WORKING to figure it out for certain.
If you can't DIY when it fails, and it gets to the point where it stays off all the time, you can swing by my place for a little help. I'm in Augusta area.
If you can't DIY when it fails, and it gets to the point where it stays off all the time, you can swing by my place for a little help. I'm in Augusta area.
#4
Navigator
Thread Starter
Member Since: Sep 2011
Location: Millen GA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Loose/broken trigger wire to the amp is my guess, but you'd have to check it with a meter WHILE IT WASN"T WORKING to figure it out for certain.
If you can't DIY when it fails, and it gets to the point where it stays off all the time, you can swing by my place for a little help. I'm in Augusta area.
If you can't DIY when it fails, and it gets to the point where it stays off all the time, you can swing by my place for a little help. I'm in Augusta area.
#5
Navigator
Thread Starter
Member Since: Sep 2011
Location: Millen GA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
#7
Tech Contributor
You have a PM.
#8
Navigator
Thread Starter
Member Since: Sep 2011
Location: Millen GA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
#9
Navigator
Thread Starter
Member Since: Sep 2011
Location: Millen GA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
If that is the way it happens every time, I'd have to guess that it's a problem with the radio itself. If the radio comes on, then it's reading the serial data line properly, but then the radio should be providing a 12v trigger to the amp so it turns on. Sounds like the radio isn't putting out either the audio signal or the trigger. But I suppose something strange could be going on with the amp also.
You have a PM.
You have a PM.
#10
Navigator
Thread Starter
Member Since: Sep 2011
Location: Millen GA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
#13
Former Vendor
#15
Tech Contributor
That confirms that they're just guessing at the amp being bad