Amp turn on
Thread Starter
Advanced
Joined: Apr 2008
Posts: 56
Likes: 4
From: ELKINS PARK PA
Amp turn on
Mark,
I know this topic has been beaten to death, but please humor me about this.
Pioneer AVH-5700BHS installed by me using PAC RP4-GM11. Unit worked fine for a few months, now no sound. All fuses good.
I understand that I have to connect blue/white wire to b3 wire.
Just one clarification please, do I leave the connection to the interface intact, and ADD a jumper AROUND interface, or, just cut blue/white wire going into interface, and connect to other side of interface.
If I cut wire going in, will I lose any functions?
Thanks,
R
I know this topic has been beaten to death, but please humor me about this.
Pioneer AVH-5700BHS installed by me using PAC RP4-GM11. Unit worked fine for a few months, now no sound. All fuses good.
I understand that I have to connect blue/white wire to b3 wire.
Just one clarification please, do I leave the connection to the interface intact, and ADD a jumper AROUND interface, or, just cut blue/white wire going into interface, and connect to other side of interface.
If I cut wire going in, will I lose any functions?
Thanks,
R
Tech Contributor
Joined: May 2003
Posts: 7,036
Likes: 135
From: North Augusta, SC
I understand that I have to connect blue/white wire to b3 wire.
Just one clarification please, do I leave the connection to the interface intact, and ADD a jumper AROUND interface, or, just cut blue/white wire going into interface, and connect to other side of interface.
Just one clarification please, do I leave the connection to the interface intact, and ADD a jumper AROUND interface, or, just cut blue/white wire going into interface, and connect to other side of interface.
