Carbon fiber wing
#21
Drifting
Thread Starter
#23
Drifting
Thread Starter
#24
Supporting Vendor
Member Since: Dec 2016
Location: Lookin over Hoover Dam
Posts: 3,513
Received 2,316 Likes
on
990 Posts
That's 84"? Actually is right at the widebody...maybe a tad wider. I'm surprised by that. I have a 72" and it's slightly narrower than the custom widebody on a C5 I had in clay. That's pretty surprising. Looks good actually...lol. I think if it had a bit more subtle end planes it'd be pretty sweet...lol. I'm a bit of a drift guy though...my bad...haha.
I'm the guy that feels GM went too small on the C7 ZR1 wing...
I'm the guy that feels GM went too small on the C7 ZR1 wing...
Last edited by KnightDriveTV; 05-01-2018 at 11:54 AM.
#25
Drifting
Thread Starter
That's 84"? Actually is right at the widebody...maybe a tad wider. I'm surprised by that. I have a 72" and it's slightly narrower than the custom widebody on a C5 I had in clay. That's pretty surprising. Looks good actually...lol. I think if it had a bit more subtle end planes it'd be pretty sweet...lol. I'm a bit of a drift guy though...my bad...haha.
I'm the guy that feels GM went too small on the C7 ZR1 wing...
I'm the guy that feels GM went too small on the C7 ZR1 wing...
#26
Drifting
Thread Starter
Well I got to test my splitter and Wing combination and even with a giant tunneled splitter 5 degrees was a bit too much Wing angle with it up above the roofline and behind the car so I'm dialing it back to 2 degrees. I think I'm also going to drop it to just below the roofline. I haven't gotten a chance to test it at autocross speeds but I know it will work because that's how this airfoil was designed. The Reynolds numbers taken into consideration during the design process was around 300,000 so I know it will work at and below 60 miles per hour
with my new setup I took almost 3 seconds off of my lap time at Thompson Speedway I went from a 1:16.6 to a 1:13.8
with my new setup I took almost 3 seconds off of my lap time at Thompson Speedway I went from a 1:16.6 to a 1:13.8
Last edited by 383; 05-14-2018 at 08:30 AM.
#29
Drifting
Thread Starter
I like this hardware better but still need to work on the upright design. I don't really like the way it looks.
what do you guys think?