They are real fun to install. I'm still working on the firewall grommet!
Grommets.
Thread Starter
Melting Slicks
Joined: Aug 2004
Posts: 2,241
Likes: 6
From: Arizona
Grommets.
I am putting in my rear light harness and am looking for the grommet that goes in the drivers side back wall where the wiring enters the vehicle. Dr. Rebuild and LIC don't list it. Is that grommet supposed to actually be there, or did someone just punch a hole there? There was remnants of an old grommet.
Safety Car
Joined: Feb 2006
Posts: 4,142
Likes: 704
It's the same grommet that is used on the firewall for the oil line and for the wiper motor, back up lamp and coil wires. Numero "C" in the pic below.
p.s......it's a thick sonofagun, you may need a sledge hammer to install it.
p.s......it's a thick sonofagun, you may need a sledge hammer to install it.
Safety Car
Joined: Jun 2000
Posts: 4,711
Likes: 552
From: St. Louis MO
2020 Corvette of the Year (appearance mods)
C2 of Year Winner (appearance mods) 2019
CI 4-5-7-9-10-11 Car Show Winner
CI 2-3-4-5-6-7-9-10-11 Vet
I've got a extra (NEW) that you can have.
Send me an email with your address
George
Send me an email with your address
George
Thread Starter
Melting Slicks
Joined: Aug 2004
Posts: 2,241
Likes: 6
From: Arizona
Safety Car
Joined: Jun 2000
Posts: 4,711
Likes: 552
From: St. Louis MO
2020 Corvette of the Year (appearance mods)
C2 of Year Winner (appearance mods) 2019
CI 4-5-7-9-10-11 Car Show Winner
CI 2-3-4-5-6-7-9-10-11 Vet
Drifting
Joined: Jul 2007
Posts: 1,671
Likes: 10
From: california
i have the sledge hammer installation installation tool!!
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Melting Slicks
Joined: Mar 2005
Posts: 2,202
Likes: 15
From: Keswick Ontario
i just did mine. what a lousy job. it became a lot easier when i got a friend to push from the engine side while i used a stiff steel dental probe type thing to pull from the back........ with a little vaseline of course......... it took 2 minutes after screwing around by myself for an hour.........