'64 Kick Panels
05-11-2009, 09:28 PM
#1
Racer
Thread Starter
Member Since: Mar 2007
Location: Eden Prairie MN
Posts: 297
Likes: 0
Received 0 Likes
on
0 Posts
'64 Kick Panels
Could anyone post or email me a few good pics of the footwell kick panel area? My AIM is no good and I just can't figure out how it all goes together as it sticks out too far.
Thanks in advance!
Rand
randalldward@msn.com
Thanks in advance!
Rand
randalldward@msn.com
05-12-2009, 02:03 PM
#3
Melting Slicks
Randy
I don't know if the 64's are the same as the 65's (don't have any books handy; someone please chime in if they're not the same) but I'll volunteer this pic of the right side kick panel from my 65. That fresh air grill is for AC (different for non-AC). Driver side is pretty much the same.
The windlace is hooked to the panel front edge and the metal trim covers the inner part of the strip.
Hope this helps a bit.
Dave Z
I don't know if the 64's are the same as the 65's (don't have any books handy; someone please chime in if they're not the same) but I'll volunteer this pic of the right side kick panel from my 65. That fresh air grill is for AC (different for non-AC). Driver side is pretty much the same.
The windlace is hooked to the panel front edge and the metal trim covers the inner part of the strip.
Hope this helps a bit.
Dave Z
05-12-2009, 04:14 PM
#5
Racer
Thread Starter
Member Since: Mar 2007
Location: Eden Prairie MN
Posts: 297
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Dave-that's the pic I needed. For some reason my panels want to stick out 3/4 in too far. They are new carpets with new cardboards but there just doesn't seem to be enough space between the vents and the verticle edge of the door opening. Must start cutting something!
Rand
Rand
