LS Midyear Conversion
Melting Slicks
Joined: May 2002
Posts: 2,225
Likes: 44
From: Penticton B.C. Canada
[QUOTE=John McGraw;1575281365]
I had considered building my own as well but I was ordering a bunch of stuff from Scoggins dickey so I just had them include their mount plates as well. The trans dapt 1" set back plates are about $40. I think.
. The only supprise is that all of the engine mount plates that say that they put the engine in the stock location is BS. They ALL put the engine 1" foreword - Including the super duper billit Scoggins Dickey units. QUOTE]
Yep, that is why I make my own plates from billet aluminum. The first car I built, I used some S&P plates, but after I saw how simple they were, I just made my own. I can build a set in about 2 hours and that beats paying close to $100 for a pair and I can make them exactly like I want!
Regards, John McGraw
Yep, that is why I make my own plates from billet aluminum. The first car I built, I used some S&P plates, but after I saw how simple they were, I just made my own. I can build a set in about 2 hours and that beats paying close to $100 for a pair and I can make them exactly like I want!
Regards, John McGraw
