Precision engineering..
Thread Starter
Drifting
Joined: Jun 2010
Posts: 1,324
Likes: 1
From: Ball Ground Georgia
Precision engineering..
Anyone have any experience with them on trailing arms. I just noticed their add in an older NCRS driveline mag (last year). They will do a complete swap inclusive of spindle and rotor for $329.
Bair's is $349 but does not include spindle or rotor...if yours is no good then there is an upcharge. Same with the trailing arm casing. I have to replace one and it is an upcharge.
Does PE's units pass NCRS judging?
You can respond PM if you don't feel comfortable posting in the thread...
thx
Bair's is $349 but does not include spindle or rotor...if yours is no good then there is an upcharge. Same with the trailing arm casing. I have to replace one and it is an upcharge.
Does PE's units pass NCRS judging?
You can respond PM if you don't feel comfortable posting in the thread...
thx
Thread Starter
Drifting
Joined: Jun 2010
Posts: 1,324
Likes: 1
From: Ball Ground Georgia
Not sure who this is for...
Anyways, I found the PE website...after reading their core policies it appears that they will have the same approach/cost as bairs when it comes to the condition of the cores. I already have the boxes from Bair's and they shipped them USPS in good faith at the cost of $15 per so I am going to go ahead and ship mine to them. I know I have to have 1 new casing but hopefully the spindles and rotors are re-useable.
