Welding Harmonic Balancer???? "RESULTS"
Thread Starter
Burning Brakes
Joined: Jan 2004
Posts: 769
Likes: 0
From: Ft. Lauderdale Fl
Welding Harmonic Balancer???? "RESULTS"
Being a good guy. I went over to his garage and he had everything ready for me. I put 2 passes on. Got good penetration on both. Each one was about 3/4". I used 7018, 1/8 a good rod. 
That was at 10:30 am. He just called 3:30 He put the vette back togather and took her for a ride. He said it broke at around 4000 rpm's. 
He made it home. The guy has had it with her and he is not going to f*%# with it until next fall. I bet he'll have her back on the road before the 4th of July. I've been putting off replacing my master cylinder. That doesn't seem like a hard job after all. I'll do it tomorrow morning so I can go to the Corvette Challange tomorrow night. 
