Trailing arm question
Thread Starter
Safety Car
Joined: Oct 2005
Posts: 3,570
Likes: 1
From: Algonac Michigan
Trailing arm question
Well I FINALLY got my arms back today after about two months, and my friend who disassembled them for free(thats why the long wait) could not get the housing for the bearings out of one of the arms. I'm doing a frame off, and I want everything to look good, so I want to get everything apart before I send all the parts out for powder coating. Any suggestions before I take a big hammer to it and damage something?
Thanks,
SLY
Thanks,
SLY
Drifting
Joined: Mar 2005
Posts: 1,806
Likes: 3
From: Burlington WI
Drifting
Joined: Jul 2005
Posts: 1,562
Likes: 2
From: Spring Texas
Post some pictures. If the spindles are out, and the nuts are off, there is nothing but rust holding them together. Use a dead blow hammer or a heavy hammer and a block of wood to tap around the spindle support and the spindle flange to get the parts to separate.
Orville
Orville
