Oil Pump Problem? Please Help!

Reply Subscribe

Thread Tools

Search this Thread

Feb 11, 2008 | 01:39 PM

Cruising91

Thread Starter

Advanced

Joined: Apr 2007

Posts: 76

Likes: 1

From: Orlando Florida

Oil Pump Problem? Please Help!

Bummer, I was just about to install my one piece oil pan gasket when I noticed that there was a crack in the plastic piece on the oil pump drive shaft. Should I fix this? Is it important, what is its function? Please help?

Feb 11, 2008 | 02:16 PM

fauxrs2

Drifting

Joined: Feb 2005

Posts: 1,738

Likes: 2

From: San diego ca

It ensures alignment of the shaft with the pump. I would replace with an aftermarket unit using a steel sleeve, they are inexpensive insurance.

Feb 11, 2008 | 02:21 PM

427basketcase

Drifting

Joined: May 2002

Posts: 1,546

Likes: 5

From: Sacramento California

Steel beats plastic every time

Feb 11, 2008 | 02:23 PM

7T1vette

Team Owner

Joined: Jan 2006

Posts: 37,637

Likes: 3,118

From: Crossville TN

I'm sure "Bubba" could come up with 20 "fixes" for that....[hose clamp, duct tape, etc. etc.]. But it would be best to replace it. Check to see if your local parts store has one. Hopefully, it will be readily available and you won't have to order by catalog. A last resort repair (but much more viable than Bubba would attempt) would be to apply a 1/8" thick band of JB Weld putty-type epoxy around the sleeve to reinforce it.

Feb 11, 2008 | 07:20 PM

noonie

Race Director

Joined: Mar 2006

Posts: 14,112

Likes: 28

From: Florida

Napa should have it. Here is their part number.

In a pinch, you can also use a "sweat coupling" for 3/8" copper pipe, not tubing, but pipe. It has worked for me over 100,000 miles.

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last

Forum Jump