Console issues
Thread Starter
Pro
Joined: Jan 2007
Posts: 589
Likes: 0
Console issues
I put my console back together and half killed myself trying to get it back in the car. I didnt think it was gonna be that hard.
Anyway it dosent seem to be sitting right. My shifter hits it in first and really moves it in reverse.. Am I missing something..I ut new carpet and an underlayment in it. Maybe the carpet is too thick?. Console seems to be in the right spot to bolt up.
Anyway it dosent seem to be sitting right. My shifter hits it in first and really moves it in reverse.. Am I missing something..I ut new carpet and an underlayment in it. Maybe the carpet is too thick?. Console seems to be in the right spot to bolt up.
Safety Car
Joined: Feb 2006
Posts: 3,557
Likes: 0
From: Ridgeway VA
I have a '70 and if yours is the original the material it's made of - and thru wear and tear - the sides seem to buckle causing problems. Just make sure the console is far enough forward - the "U" bracket that supports the front and radio might also need to be tightened.
Le Mans Master
Joined: Jul 2006
Posts: 8,117
Likes: 104
From: charlotte north carolina
i had the same problem wth my 70 rebuild. i shimmed the shifter bracket per the aim and it helped somewhat, but finally changed to the short throw shifter holes and have clearance in 1st and 3rd now. reverse still hits the plate, but these cars were designed to go forward anyway!
jeff
jeff
Drifting
Joined: Oct 2007
Posts: 1,254
Likes: 5
From: Brown Summit North Carolina
Merlinhaggard , sounds like this was not happening before you took the console out.
When I re installed mine last December I ran into the same thing.
What I found was that I had used too large a washer where the gaude bezel studs pass thruy the front upper part of the shifter console. this prevented me from sliding the console fully forward.
This is most evident by looking at the spot where the left and right dash panels come into contact with the shifter console.
Look at this spot to see if they are touching or is there a gap?
That gap will confirm that you do not have the console fully foward.
Is so that 3/8 to 1/2" will cause your shifter to hit the front edge of the cut out in the console.
Hope this helps
David
When I re installed mine last December I ran into the same thing.
What I found was that I had used too large a washer where the gaude bezel studs pass thruy the front upper part of the shifter console. this prevented me from sliding the console fully forward.
This is most evident by looking at the spot where the left and right dash panels come into contact with the shifter console.
Look at this spot to see if they are touching or is there a gap?
That gap will confirm that you do not have the console fully foward.
Is so that 3/8 to 1/2" will cause your shifter to hit the front edge of the cut out in the console.
Hope this helps
David
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Every 2027 Corvette Engine Explained
Joe Kucinski
Designer Imagines A Corvette That Looks More Like a Corvette Than the Corvette
Verdad Gallardo
10 Ugly Corvettes That We Still Kinda Love
Joe Kucinski
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
