Steeroids Installation Documented
Thread Starter
Drifting
Joined: Jan 2001
Posts: 1,841
Likes: 3
From: Halifax, NS, Canada
Steeroids Installation Documented
I have documented my Steeroids installation on my website. If you are contemplating going this route you might want to check out the page at
http://corvettec3.ca/steeroid.htm
http://corvettec3.ca/steeroid.htm
Thread Starter
Drifting
Joined: Jan 2001
Posts: 1,841
Likes: 3
From: Halifax, NS, Canada
There is no question that the car steers easier and more responsive. I did not replace my original pump so I am still using the 30+ year old original. I expect that with a new pump I would even notice more improvement. Steering is quicker, the turns lock to lock are less than with the original system. Because at the same time I installed the Steeroids kit, I also installed the monospring kit so I made two major changes at the same time so it is difficult to know what impacted the handling most.
C6 the C5 of tomorrow
Joined: Nov 2000
Posts: 6,665
Likes: 2
From: Twin Cities Minnesota
documentation is good !
Remember that even though you have fewer turns lock to lock, you also have a larger turning circle. You steering rate is the same.
at least mine was, there may be more than one rate.
Remember that even though you have fewer turns lock to lock, you also have a larger turning circle. You steering rate is the same.
at least mine was, there may be more than one rate.
Thread Starter
Drifting
Joined: Jan 2001
Posts: 1,841
Likes: 3
From: Halifax, NS, Canada
I have adjusted the steering stops on my control arms to give me the same turning radius that I had with the original system. I did not mention that in my document as I knew the majority would be using the original control arms.
