Finally - Front end Done!
Thread Starter
Melting Slicks
Joined: Jun 2009
Posts: 2,343
Likes: 4
From: Anderson SC
Finally - Front end Done!
Now all I need is a day or three under 90 degrees to reinstall it all.
-W
click image for big image
-W
click image for big image
Last edited by Clams Canino; Aug 21, 2010 at 12:00 PM.
Drifting
Joined: Mar 2008
Posts: 1,900
Likes: 2
From: Nixa Missouri
Nice set up indeed. 
I too wish for any relief in this heat today but still "trying" to march on the best I can to get the car down on the ground to torque up the A-arm bushing bolts. I've had a few set backs and in no way going to get in a hurry now and take any short cuts after all this time and work I've done to the car.
BTW, I like the red stabilizer bar.
I too wish for any relief in this heat today but still "trying" to march on the best I can to get the car down on the ground to torque up the A-arm bushing bolts. I've had a few set backs and in no way going to get in a hurry now and take any short cuts after all this time and work I've done to the car.BTW, I like the red stabilizer bar.
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Top 10 Corvette Engines RANKED by Peak Torque (70+ Years of Muscle!)
Joe Kucinski
Corvette ZR1X Will Be Pacing the Indy 500, And Could Probably Race, Too!
Verdad Gallardo