76 so far....
Thread Starter
Drifting
Joined: Jun 2011
Posts: 1,541
Likes: 268
From: iowa city iowa
2020 Corvette of the Year Finalist (appearance mods)
C3 of Year Winner (appearance mods) 2019
76 so far....
I have been plugging away at it for a while, and thought I would post a picture of the 76 so far... I just got the wheels and got them on, but have not changed out the rear tires yet. The wheels came off of Kaoss (thanks again, Rob), and it is amazing what a difference a set of wheels makes, even on a roller.
I need to figure out what u-joints I need for the drive shaft (it is a richmond 6) and get that installed as well as the fuel lines and I think I will be ready to put the body on.
I need to figure out what u-joints I need for the drive shaft (it is a richmond 6) and get that installed as well as the fuel lines and I think I will be ready to put the body on.
Burning Brakes
Joined: May 2008
Posts: 860
Likes: 0
From: Stratford Ontario
Thats going to be a great ride when its done. The hard part is when the body goes back on it looks like not much has been done. Keep up the good work and it will look amazing when your done.
Thread Starter
Drifting
Joined: Jun 2011
Posts: 1,541
Likes: 268
From: iowa city iowa
2020 Corvette of the Year Finalist (appearance mods)
C3 of Year Winner (appearance mods) 2019
Wow, thanks for that. I did not even know about driveline phasing. I am reading up on it now and it makes my brain hurt.
