Strut rod bushing
Thread Starter
Instructor
Joined: Apr 2011
Posts: 217
Likes: 0
From: Shearwater Nova Scotia
Strut rod bushing
Good evening,
Having purchased a suspension rebuild kit, the new strut rods have concerning features - there is no rubber 'washer' at the front of the strut rod that connects to the wheel hub.
New strut rod
Where as the original - the bushing was flush with the grommet as seen here.
I am about to put this back together - should I be concerned about missing the extra rubber here?
Thanks
Having purchased a suspension rebuild kit, the new strut rods have concerning features - there is no rubber 'washer' at the front of the strut rod that connects to the wheel hub.
New strut rod
Where as the original - the bushing was flush with the grommet as seen here.
I am about to put this back together - should I be concerned about missing the extra rubber here?
Thanks
Team Owner
Joined: Sep 2006
Posts: 31,301
Likes: 4,389
From: Westminster Maryland
Hi,
Might the difference be you're comparing the 63-74 1-1/4" bushing with the 75-79 1-3/8" bushing?
Also, notice the note describing the protruding rubber on the 63-74 bushing.
Regards,
Alan
Might the difference be you're comparing the 63-74 1-1/4" bushing with the 75-79 1-3/8" bushing?
Also, notice the note describing the protruding rubber on the 63-74 bushing.
Regards,
Alan
Thread Starter
Instructor
Joined: Apr 2011
Posts: 217
Likes: 0
From: Shearwater Nova Scotia
Not exactly. The original strut rods definitely have a rubber bushing that is flush - like the poly bushing shown below.
Poly strut bushing
The question I guess I am asking is: can I put this strut rod on that car as is?
Just feels like it really is missing that extra piece of rubber....
Poly strut bushing
The question I guess I am asking is: can I put this strut rod on that car as is?
Just feels like it really is missing that extra piece of rubber....
