spark plug wire looms.
#1
Race Director
Thread Starter
spark plug wire looms.
Does anyone make a wire loom for larger 8mm and 8.5 mm wires that clip to the tops of the stock chrome valve covers. I bought the ones for the stock wires but my plug wires were to big for them.
#2
Team Owner
just loop a zip tie around all 4 wires,then before tightening,loop a zip tie inbetween each wire,and take-off the plastic adapter and loop a ziptie thru the hole in the steel on the valve cover
https://www.hotrod.com/articles/wren...ose-organizer/
https://www.hotrod.com/articles/wren...ose-organizer/
Last edited by dmaxx3500; 07-12-2018 at 05:48 PM.
The following users liked this post:
LenWoodruff (07-13-2018)
#3
Racer
just loop a zip tie around all 4 wires,then before tightening,loop a zip tie inbetween each wire,and take-off the plastic adapter and loop a ziptie thru the hole in the steel on the valve cover
https://www.hotrod.com/articles/wren...ose-organizer/
https://www.hotrod.com/articles/wren...ose-organizer/
very good idea...cool