Holley Sniper efi
#1
Instructor
Thread Starter
Holley Sniper efi
Just completed my sniper install and just wanted to know where others ran the hand held monitor wire to the inside.
Thanks
Thanks
The following users liked this post:
TexasYankee (08-03-2018)
#3
Melting Slicks
Why do you need the monitor inside the car? It is just a tool for the settings, diagnostics, and fine tuning. I drove mine around awhile monitoring the engine, now it sits on the bench. T
#4
Burning Brakes
Good question.I hope someone responds.
On a side note: I just replaced my tired old Crossfire setup with a new Holley Sniper EFI and I'm so glad I did. I fought that Crossfire on my 82 for 13 years and finally had enough.
On a side note: I just replaced my tired old Crossfire setup with a new Holley Sniper EFI and I'm so glad I did. I fought that Crossfire on my 82 for 13 years and finally had enough.
#5
Melting Slicks
I just ran my Fitech handheld wire thru one of the factory firewall access holes, tach/speedo I think. I monitor parameters all the time. plus I like to tweak here and there.