Brake Bleeding
Melting Slicks
Joined: Jun 2014
Posts: 2,236
Likes: 498
From: NJ
Not sure if the MC lid is symmetrical but....you should be able to not cut the gasket between the reservoirs and just turn the lid to bleed the other reservoir. You have to remove the lid to check the fluid level when your bleeding anyway. Just sayin' . Great setup though.
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Le Mans Master
Joined: Aug 2017
Posts: 8,336
Likes: 2,810
From: Cool Northern Michigan
Well, if you trust the gauge on the Motive tank, I believe it was running 15lb. I start high, then pump it up again after doing a caliper or two.
It doesn't take much to force a good stream out the caliper.
What is lacking on those tanks is a good shut-off valve in the line just in case something goes wrong. Just like a garden tank sprayer, to stop flow, you have to turn the tank handle and release pressure. This is where you should place a towel over the tank so as not to spray your paint job.
It doesn't take much to force a good stream out the caliper.
What is lacking on those tanks is a good shut-off valve in the line just in case something goes wrong. Just like a garden tank sprayer, to stop flow, you have to turn the tank handle and release pressure. This is where you should place a towel over the tank so as not to spray your paint job.