When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So I was wondering if anyone had experience with this particular distributor. I will get it in the mail soon and was hoping it would fit under the shielding - it's actually as small as the stock distributor, so I'm thinking it might.
Looks like a MSD knock off of the corvette tach drive dist. #8572 I think. If it is you can just put the stock style female dist cap on it. That’s what I did with my MSD. The cap that is on it may be too tall to fit under the shielding.I didn’t bother to try that cap because I did not want to change to plug wires that fit the male terminals on that cap.
you could raise the lower shielding up by re drilling the 2 holes on both sides down 1/2" or so
did this on my 68 worked great
Great idea - thanks for that! When I got the car, the old distributor had been replaced by a large HEI unit with no tach drive. So this solves 2 problems - gets my tach working and gives me a more stock look (with the shielding) while
allowing for the convenience of an HEI unit over points.