Q: on banjo fitting......
Thread Starter
Melting Slicks
Joined: Jan 2005
Posts: 3,028
Likes: 0
From: Madison Ms
Q: on banjo fitting......
I was looking at putting the banjo fitting on my EB carb, but I got to scratching my head when I took it out of the package. Their are holes in the piece that screws into the carb, and one outlet hole on the piece that turn down. Do these holes have to line up? Looks very restrictive to me......
Tech Contributor
Joined: Aug 1999
Posts: 14,380
Likes: 6,390
From: At my Bar drinking and wrenching in Lafayette Colorado
The bolt that goes through the fitting is a necked bolt, so the holes do not need to line up: the fuel flows around the necked part of the bolt, allowing the fitting to be rotated to any position.
Team Owner
Joined: May 2001
Posts: 29,745
Likes: 3
From: Exiled to Richmond, VA - Finally sold my house in Murfreesboro, TN ?? Corner of "Bumf*&k and 'You've got a purdy mouth'."
CI 6-7-8 Veteran
CI-VIII Burnout Champ
St. Jude Donor '06-'10, '13
Originally Posted by lars
The bolt that goes through the fitting is a necked bolt, so the holes do not need to line up: the fuel flows around the necked part of the bolt, allowing the fitting to be rotated to any position.
