Motive Powerbleeder Question
Thread Starter
Racer
Joined: Dec 2000
Posts: 472
Likes: 0
From: Springfield GA
Motive Powerbleeder Question
Quick question, when you're finished bleeding using this pressure bleeder, how do you equalize the pressure before removing the lid to keep from sucking the master cylinder dry of brake fluid?
Thread Starter
Racer
Joined: Dec 2000
Posts: 472
Likes: 0
From: Springfield GA
Safety Car
Joined: Jun 2004
Posts: 4,372
Likes: 223
From: Beecher Illinois
One thing I do when I finish bleeding. I turn the tank on it's side and open the left front bleeder again and watch the air gap in the hose until it gets to the master. Then just slowly open the lid of the tank. Kinda saves a little bit of cleanup, the fluid in the line dribbling out all over things as you remove it from the master.
Mike
Mike
Last edited by KapsSA; Jan 5, 2007 at 08:24 PM.
