Transmission Question !
Thread Starter
Instructor
Joined: Mar 2007
Posts: 183
Likes: 0
From: Corpus TX
Transmission Question !
Im in the in the last stages before i fire up my babies new heart, and i need to conect the tranny lines . I was wondering if anybody had any ideas on how to do it ( i really dont want to make my own lines ) rubber, steel, alum,braided or even used or new pre bent !!!!!! THANKS
Racer
Joined: Oct 2005
Posts: 457
Likes: 1
From: Royal Oak Michigan
I replaced my TH350 with a 2004R and had to create new lines. I used the old ones a guide. My neighbor had a rear nice bender. After a few tries I finally was able to get the proper routing. I created 2 lines but i had to scrap 2 because of errors. I thiink what I would do if I had to do it again without the old ones as a guide is try and find some plastic rods and bend (melt) them to the right route and then use them as a guide to create the new ones.
Darrel1
Darrel1
Le Mans Master
Joined: Jan 2006
Posts: 9,192
Likes: 27
From: Boca Raton Florida
Get an 18" extruded aluminum cooler off ebay and a pair of 18" braided lines from Summit or wherever and put the cooler on the frame uneder the car in the slipstream. Nice and clean
