HP & Torque Estimates
Thread Starter
Racer
Joined: Mar 2006
Posts: 313
Likes: 0
From: Fairfield PA
HP & Torque Estimates
What kind of HP and Torque could I expect to get from this combination.
Specs:
383
Dart pro 1 heads 64cc 2.05/1.60" (haven't bought yet)
Edelbrock RPM Air Gap
Automatic with 3.73 gears
Edelbrock Performer 750
Stall Converter is B&M Holeshot 2400
Crane Cam 224/230 @.050 & 473 Intake/486 Exhaust
Eagle Rotating Assembly (Internally Balanced)
-Forged 4340 Crank
-Forged 4340 Connecting Rods
-Forged Dish Pistons 16cc
Head Gasket will be .040 thick
Specs:
383
Dart pro 1 heads 64cc 2.05/1.60" (haven't bought yet)
Edelbrock RPM Air Gap
Automatic with 3.73 gears
Edelbrock Performer 750
Stall Converter is B&M Holeshot 2400
Crane Cam 224/230 @.050 & 473 Intake/486 Exhaust
Eagle Rotating Assembly (Internally Balanced)
-Forged 4340 Crank
-Forged 4340 Connecting Rods
-Forged Dish Pistons 16cc
Head Gasket will be .040 thick
Le Mans Master
Joined: May 2006
Posts: 9,993
Likes: 1,136
From: League City Tx
Kind of broad info but if I was to guess, I would say the motor will make 400-420 crank hp, going through a TH400 and IRS I would think it should get around 300hp to the wheels. Thats enough for 12.70-12.80s with the right converter. I would stay away from a B&M 2400 though unless you already have it.
Race Director
Joined: Apr 2000
Posts: 17,676
Likes: 201
From: Who says "Nothing is impossible" ? I've been doing nothing for years.
Not sure why, but you are building a new engine capable of over 500HP and you want 400HP ? Up the cam and compression and build it right 
