Best U-joints
Team Owner
Joined: Oct 2004
Posts: 23,831
Likes: 10
From: Springfield MO
St. Jude Donor '07
Le Mans Master
Joined: Apr 2005
Posts: 6,346
Likes: 418
From: Seattle Area WA
I just installed some half shafts and trailing arms for a guy who bought everything from Ecklers. The U-joints were GMB brand with zerks...gack!! I informed him that this was not a good idea for his '69 427/435, his reply was they were only $18 each....go figure. I asked, ever see the tubs of a Corvette torn up as a result of cheap U-Joints,
it didn't seem to matter.
it didn't seem to matter.
Thread Starter
Drifting
Joined: Oct 2007
Posts: 1,458
Likes: 1
From: Collinsville MS
St. Jude Donor '08
you think the Brute force will be ok for my ride? Its a 350 that I figure has about 280 hp right now. It probably won't see much more than that. I dont do a lot of tire spinning, it gets too expensive at times.
Pro
Joined: Aug 2005
Posts: 627
Likes: 1
From: Naperville IL
I went with the brute force joints from autozone and they were a lot beefier than whatever came off the car, I don't think you'll have any problems with them on a small block.
not the best picture, but gives you an idea
not the best picture, but gives you an idea
Race Director
Joined: May 2005
Posts: 10,674
Likes: 122
From: Millington Illinois
St. Jude Donor '08-'09
