Hard top question
Le Mans Master
Joined: Sep 2001
Posts: 7,739
Likes: 630
From: Unreconstructed, South Carolina
Should be two chromed die cast blocks screwed to rear of hardtop R&L ... each w/ a female threaded hole on underside ... you can buy more arrowheaded pins like on your rag top & screw them in or you can use common allthread/threaded rod from hardware store w/ some nuts & washers. Be careful with those threads in that die cast!!! Don't force anything or it'll surely crack/strip!!!
seems like the last detail had a pretty good selection of those kinda parts at decent $
www.TLD-corvette.com
http://www.tld-corvette.com/prodinfo.asp?number=595360
seems like the last detail had a pretty good selection of those kinda parts at decent $
www.TLD-corvette.com
http://www.tld-corvette.com/prodinfo.asp?number=595360
Last edited by jackson; Dec 27, 2007 at 10:54 AM.
Racer
Joined: Feb 2007
Posts: 389
Likes: 7
From: Cliffwood Beach NJ
The earlier cars and tops did not attach in the back (my 68 does not). Does your top have the pin and the deck does'nt have a corresponding latch? Some people would just cut the pin and be done with it. Not sure what you would do if you wanted the pin. Do a search as I beleive this was a topic about a year ago and there may be pictures.
