Help!!! What is the thread front bracket?
Thread Starter
1st Gear
Joined: Jan 2004
Posts: 1
Likes: 0
From: Simi Valley Ca
Help!!! What is the thread front bracket?
I'm trying to find the thread size of the upper hole on the front spindle on the 69 Corvette. I believe it's a 5/8 but I'm unsure of the pitch.
Can anyone help???
Thx, Matt
Can anyone help???
Thx, Matt
Team Owner
Joined: Sep 2006
Posts: 31,274
Likes: 4,366
From: Westminster Maryland
Matt,
Not sure what you mean. The nut that is used to mount the spindle to the upper ball joint is 1/2" x 20 according to my parts book. Now that I reread your post I guess you mean the bolt that mounts the dust shield... and that's not in my book. I have the bolt in my hand and it's a very fine thread. Sorry, I don't have a gauge to measure it.
Regards,
Alan
Not sure what you mean. The nut that is used to mount the spindle to the upper ball joint is 1/2" x 20 according to my parts book. Now that I reread your post I guess you mean the bolt that mounts the dust shield... and that's not in my book. I have the bolt in my hand and it's a very fine thread. Sorry, I don't have a gauge to measure it.
Regards,
Alan
Team Owner
Joined: Oct 2004
Posts: 23,831
Likes: 10
From: Springfield MO
St. Jude Donor '07
If you're talking about the big sucker that holds the top of the dust shield down, it's a real freak of a bolt. Van Steel has them available, that's where I found replacements.
