Removing header bolt with factory A/C
Thread Starter
Racer
Joined: Feb 2012
Posts: 390
Likes: 1
From: Livonia MI
Removing header bolt with factory A/C
Before I go and do something stupid on my newly purchased 1981 vette, what's the easiest way to remove the forward most header bolt on the right side of my engine? The factory A/C bracket is attached to the botlt, and the coolant line runs right next to it.
Any help would be appreciated.
Any help would be appreciated.
Thread Starter
Racer
Joined: Feb 2012
Posts: 390
Likes: 1
From: Livonia MI
So, just remove the lower bracket without removing the compressor? 'Cause the compressor can't go anywhere without disconnecting the hoses.
Team Owner
Joined: Jan 2006
Posts: 37,637
Likes: 3,118
From: Crossville TN
You can rig up a way to 'hang' the compressor with it still connected to the hoses. Mechanics do it all the time. But, I would suggest that you not hang it from the hood. Perhaps a 2x2 laid across the fenders (properly padded, of course). Or, maybe there's a bracket on the inside of the right fender that has the strength to suppor that additional amount of weight. Get creative; just stay safe and keep the car safe, too. 
Safety Car
Joined: Jun 2004
Posts: 4,374
Likes: 224
From: Beecher Illinois
I've pulled the compressor to the side. A piece of wire in the hole in the fender lip that the side intake duct screwed into.
Of course, now you gotta take the duct out, but that will give you a whole lot more room to work.
Of course, now you gotta take the duct out, but that will give you a whole lot more room to work.
