rear 82 spring sagging
Thread Starter
5th Gear
Joined: May 2012
Posts: 5
Likes: 0
rear 82 spring sagging
hi guys new to the corvette world from sunny england...
i have recently bought a 82 vette the rear is sagging bady to the d/s it has the mono spring... do these still sag? like the steel ones. looking at swapping it out if so. if not it may be other problems if not..
thank you.
i have recently bought a 82 vette the rear is sagging bady to the d/s it has the mono spring... do these still sag? like the steel ones. looking at swapping it out if so. if not it may be other problems if not..
thank you.
Le Mans Master
Joined: Aug 2010
Posts: 9,272
Likes: 17
with the plastic spring, its pretty common on C4's,and usually adjustable with the bolts on the end of the spring. havent had issues with my C3. I actually swapped ends on my C4 spring cause it was sagging bout 1 1/2" low to the drivers side, and it leveled to bout 1/4" high on the drivers side, which when I was sitting in it , leveled it out. Something else to check would be the condition of the rubber bushings. If you have any experience with the mid 70's Triumph Spitfires and others with the transverse spring, all those tricks will work on these also, hope this helps.
btw , check for the proximity to heat as the prev. poster stated.
btw , check for the proximity to heat as the prev. poster stated.
Race Director
Joined: Jul 2000
Posts: 16,532
Likes: 2,410
From: Out Where the Buses Don't Run, Eglin AFB/ Niceville FL
2025 C8 Z06/7/E-Ray of the Year Finalist - Unmodified
2022 Corvette of the Year Finalist -- Modified
2021 C6 of the Year Winner - Modified
2020 C7 of the Year Finalist -- Modified
2020 C6 of the Year Finalist - Modified
Check it for cracks as well. I just replaced a front spring on a C4 due to sagging. It was cracked in two places. Cheers!
