Fuel Fitting Help
Thread Starter
Burning Brakes
Joined: Aug 2001
Posts: 1,244
Likes: 24
From: Austin TX
Fuel Fitting Help
This is probably a Lars question, but please feel free to chime in!
I have a new Edelbrock fuel pump that has a 3/8 NPT female inlet. The stock steel line runs to about 1 foot of the pump. It terminates into a rubber line that runs the last foot to the existing fuel pump. What is the best way to bridge this game going forward? I need to go from the 3/8 NPT female inlet on the pump to the steel fuel line (about a foot or so).
Any help is appreciated!
I have a new Edelbrock fuel pump that has a 3/8 NPT female inlet. The stock steel line runs to about 1 foot of the pump. It terminates into a rubber line that runs the last foot to the existing fuel pump. What is the best way to bridge this game going forward? I need to go from the 3/8 NPT female inlet on the pump to the steel fuel line (about a foot or so).
Any help is appreciated!
Race Director
Joined: Mar 2006
Posts: 14,112
Likes: 27
From: Florida
Most parts stores have them in either straight or 90° in just brass.
http://www.jegs.com/i/JEGS-Performan...rentProductId=
http://www.jegs.com/i/JEGS-Performan...rentProductId=
Thread Starter
Burning Brakes
Joined: Aug 2001
Posts: 1,244
Likes: 24
From: Austin TX
Most parts stores have them in either straight or 90° in just brass.
http://www.jegs.com/i/JEGS-Performan...rentProductId=
http://www.jegs.com/i/JEGS-Performan...rentProductId=
