Hooker header exhaust kit
Thread Starter
Melting Slicks
Joined: Jul 2010
Posts: 2,503
Likes: 33
From: McGrady NC
St. Jude Donor '15-'16
Hooker header exhaust kit
Does anyone have any experience installing the Hooker header-back Corvette exhaust system? Since I have Hooker headers I'm hoping it will work so I can replace the crush bent system the local shop installed for me a couple of years ago. The system on it now looks pretty amateurish and my rear spring actually hits it occasionally. The Hooker setup looks pretty good. Any experience, help, tips appreciated.
Thanks!
Kim
Thanks!
Kim
Le Mans Master
Joined: Oct 2010
Posts: 6,936
Likes: 848
From: melbourne florida
2023 C3 of the Year Finalist - Modified
although no one mentions them much, i was told a few years ago that the hooker mufflers sounded very well and flowed the best. i thin you would be happy with them.
Thread Starter
Melting Slicks
Joined: Jul 2010
Posts: 2,503
Likes: 33
From: McGrady NC
St. Jude Donor '15-'16
I have the old-style crossmember ready to bolt in. The kit arrived yesterday and looks pretty good in the box. I was just wanting to hear if anyone had experience installing it. The kit didn't have mufflers with it so I have Magnaflow clones to go on it. I started removing the old system today. Too bad my SawZall is at my son's house or I would just chop it up.
Le Mans Master
Joined: Jul 2000
Posts: 6,664
Likes: 162
From: columbia city in
I have a complete hooker headers to tailpipe on my 2002 camero.The fit was good, easy install.Only complaint was the headers were hot jet coated but changed color after one year.sound is loud at wot.i would buy them again.
Le Mans Master
Joined: Aug 2010
Posts: 5,339
Likes: 546
From: Central Texas
I have the Hooker system on my '81. The cross member had to be modified to fit for one side to fit. The pipes are only 2.25 inches. The mufflers are very quiet. That being said... all in all I think it was a great kit to use for the price.
Thread Starter
Melting Slicks
Joined: Jul 2010
Posts: 2,503
Likes: 33
From: McGrady NC
St. Jude Donor '15-'16
The pipes side to side are slightly different. The instructions show where each pipe goes but there seems to be no part numbers on the pipes so it looks like trial and error will be the way to figure it out. My kit had no mufflers, just pipes and attaching hardware. I ordered mufflers separately. Mandrel bent 2.25 looks better than the crush bent set I pulled off it. By a long shot.
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski