Courtesy light
Thread Starter
Advanced
Joined: Oct 2006
Posts: 54
Likes: 2
Courtesy light
I recently purchased a nos courtesy bracket. Based on great previous pics that I received, I now know how it should be installed on the kick panel. However, I bought the wrong screw required to install it. I would greatly appreciate it if someone could send or post an up close pic of the correct black oxide hex-head screw. Not sure what screw head should look like. Thank you in advance.
Team Owner
Joined: Sep 2006
Posts: 31,301
Likes: 4,389
From: Westminster Maryland
Hi btd,
Perhaps like this?
Hex recessed head with captive flat washer sheet metal screw with I believe manganese phosphate plating, not black oxide.
It has a capital 'A' in 2 concentric circles as a head mark. I don't know how typical this mark may or may not be.
Regards,
Alan
Perhaps like this?
Hex recessed head with captive flat washer sheet metal screw with I believe manganese phosphate plating, not black oxide.
It has a capital 'A' in 2 concentric circles as a head mark. I don't know how typical this mark may or may not be.
Regards,
Alan
Last edited by Alan 71; Jun 9, 2016 at 03:33 PM.
Thread Starter
Advanced
Joined: Oct 2006
Posts: 54
Likes: 2
Hi btd,
Perhaps like this?
Hex recessed head with captive flat washer sheet metal screw with I believe manganese phosphate plating, not black oxide.
It has a capital 'A' in 2 concentric circles as a head mark. I don't know how typical this mark may or may not be.
Regards,
Alan
Perhaps like this?
Hex recessed head with captive flat washer sheet metal screw with I believe manganese phosphate plating, not black oxide.
It has a capital 'A' in 2 concentric circles as a head mark. I don't know how typical this mark may or may not be.
Regards,
Alan
Thanks for the pic. The screw is for a MY 1972 without a/c. Do you have any pics of the screw head which I can show to a vendor?
