Aluminum Intake -Big block Hood Clearance Question
#1
Racer
Thread Starter
Aluminum Intake -Big block Hood Clearance Question
I know this subject has been beat to death but I found a Weiand Street Warrior intake that no one here has discussed yet. I have the LT1/BB hood on my 72' and am wondering if you guys think this may work. Their website lists it as a LOW rise dual plane that fits both Holley and Rochester carbs. It has a height of 4.25" front and 5.42" rear,which is lower than their Stealth model. I want to use it with my Quadrajet,anybody have an opinion-I can't seem to find specs on factory steel or LS6 aluminum intake to compare it to. Here is alink to the intake: http://www.holley.com/products/intak.../parts/8123WND
Last edited by spitfun; 03-31-2017 at 06:38 AM.
#2
Le Mans Master
Member Since: Mar 2001
Location: Watkinsville, GA and Glen Cove, NY
Posts: 5,789
Received 855 Likes
on
626 Posts
I don't think it will fit. See the post in this thread with a home made measurement. I had the 569 on my car with the stock BB hood and that intake was very low!
https://www.corvetteforum.com/forums...rb-height.html
https://www.corvetteforum.com/forums...rb-height.html
#3
Racer
Thread Starter
Looks like about an inch difference from the 569,maybe with a dropped filter? I wonder of a Holley carb is taller or shorter than my Rochester.
Last edited by spitfun; 03-31-2017 at 07:10 AM.