Right Blinker Sticking on '81 - CorvetteForum - Chevrolet Corvette Forum Discussion

Notices
C3 Tech/Performance V8 Technical Info, Internal Engine, External Engine, Basic Tech and Maintenance for the C3 Corvette

Right Blinker Sticking on '81

Reply

 
 
 
Old 08-12-2018, 12:19 AM
  #1  
NateAggs
Junior Member
Thread Starter
 
Member Since: Jun 2018
Location: College Station, TX
Posts: 2
Thanked 0 Times in 0 Posts
Default Right Blinker Sticking on '81

Hey guys, I'm new to doing maintenance myself on my '81 vette. Right now, my right blinker is sticking. The bulb works on the dash, but it stays lit and doesn't blink.

I did a walk around of the car, the left blinker works great on the front left, left-side, and left rear. When I switch it to the right blinker, I get no lights on the front right, right-side, and right rear. When I turn on the hazards, the left blinkers blink, and the front right and right side blinker blink, but not the rear blinker.

Does anybody know what's happening? My assumption is there is a bad relay.
NateAggs is offline  
Reply With Quote
Old 08-12-2018, 07:06 AM
  #2  
LenWoodruff
CF Senior Member
 
LenWoodruff's Avatar
 
Member Since: Jul 2017
Location: Frisco TX
Posts: 388
Thanked 20 Times in 18 Posts
Default

Originally Posted by NateAggs View Post
Hey guys, I'm new to doing maintenance myself on my '81 vette. Right now, my right blinker is sticking. The bulb works on the dash, but it stays lit and doesn't blink.

I did a walk around of the car, the left blinker works great on the front left, left-side, and left rear. When I switch it to the right blinker, I get no lights on the front right, right-side, and right rear. When I turn on the hazards, the left blinkers blink, and the front right and right side blinker blink, but not the rear blinker.

Does anybody know what's happening? My assumption is there is a bad relay.
Turn on the parking lamps to see if any of the bulbs are burnt out.
LenWoodruff is offline  
Reply With Quote
Old 08-12-2018, 07:23 AM
  #3  
pigfarmer
CF Senior Member
 
pigfarmer's Avatar
 
Member Since: Sep 2016
Location: Dutchess county New York
Posts: 384
Thanked 68 Times in 54 Posts
Default

Originally Posted by NateAggs View Post
Hey guys, I'm new to doing maintenance myself on my '81 vette. Right now, my right blinker is sticking. The bulb works on the dash, but it stays lit and doesn't blink.I did a walk around of the car, the left blinker works great on the front left, left-side, and left rear. When I switch it to the right blinker, I get no lights on the front right, right-side, and right rear. When I turn on the hazards, the left blinkers blink, and the front right and right side blinker blink, but not the rear blinker.
Does anybody know what's happening? My assumption is there is a bad relay.
Just had something similar. Turn signals OK with lights off. Turn on the headlights and the passenger side low beam was dim and the right turn arrow lit up solid and the front turn signal bulb did not work. It actually did still blink but so slowly it was hard to even notice. Poor ground and it's shared between the low beam and the directional - at least on mine. I pulled the connector off the back of the headlight and when I cleaned off the crud one of the pins was dirty and pushed back in the connector. A little cleanup and it's fine now.

The hazard relay and the blinker relays are separate. On my 69 one is on the fuse block and the other is just under the passenger side dash in a bracket. From what you described I might start with the hazards and check out that right rear socket & bulb

pigfarmer is offline  
Reply With Quote
Old 08-12-2018, 08:35 AM
  #4  
L88Plus
CF Senior Member
 
Member Since: Aug 2004
Location: Lubbock TX
Posts: 1,641
Thanks: 0
Thanked 30 Times in 26 Posts
Default

Have you changed the fluid? The old stuff will cause all sorts of issues when it gets old and the "crick, crick" additive goes south.
L88Plus is offline  
Reply With Quote
Old 08-17-2018, 07:27 PM
  #5  
sambrand
CF Senior Member
 
Member Since: May 2018
Posts: 124
Thanked 19 Times in 18 Posts
Default

change the bulbs, odds are you have a broken filament that is intermitantly connecting, the flasher is a possibility but I cant ever recall one that went bad unles there was serious electrical short in the system. even if the bulb looks good doesn't mean the filament isn't broken inside.
sambrand is offline  
Reply With Quote
Old Yesterday, 06:38 PM
  #6  
NateAggs
Junior Member
Thread Starter
 
Member Since: Jun 2018
Location: College Station, TX
Posts: 2
Thanked 0 Times in 0 Posts
Default

@sambrand That was it! One of the bulbs was bad, and then I also found out that I had a poor grounding connection to the rear blinker. Thanks for the help!
NateAggs is offline  
Reply With Quote
 
 
 


Thread Tools
Search this Thread
Sponsored Ads
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
 
  • Ask a Question
    Get answers from community experts
Question Title:
Description:
Your question will be posted in: