How to remove slightly worn axles from 1980 diff
Thread Starter
Racer
Joined: Feb 2022
Posts: 301
Likes: 170
From: Alabama
I still stand by my previous post about the Dana 44. The fact is don't matter if an aftermarket part is made in the USA or it's Chinese. They are all junk. Ditto for the rebuilt stuff too. I much rather reuse a OEM part if I feel it's still useable then new aftermarket. I have a new pinion shaft along with other stuff coming today from Zip. I can only hope it will last. I asked in another thread who has good yokes and since no one could recommend any I'll reuse my yokes with the unworn harden surface that is the only part of the yoke that comes into contact with the pinion shaft. I see nothing wrong with your yokes that a file can't clean up. The folks on this forum love to change parts. Sometimes there's no need to and sometimes you're better leaving it alone. I know this is going to **** people off but sometimes the "well respected knowledgeable" folks here post things that leave me scratching my head. I'm no longer going to respond to this post.
