When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm installing a new wiring harness and I can't figure out the OE connections for the windshield wiper limit switch. My wiring diagram shows two 12 ga red/white wires comng out of a two wire connector and going into a block but I cannot find them coming out of a block anywhere on the diagram.
Additionally, I have a single 14g red wire exiting the wiring harness near the wiper motor that doesn't seem to connect to anything.
Any ideas appreciated.....
I cant help you on the limit switch but the extra red wire was an extra on my 68 also.My car is at a freinds house and its getting wired up and mech work done but he said everything hooked up except the red wire near the wiper motor.Good luck. :seeya
PaintDaddy,
I have looked at a couple of 71s at a car show and determined that the "extra" red wire is supposed to connect to a red wire coming out of the lower driver side of the wiper motor. My replacement motor does not have this lead. Does yours?
I am not sure about 68's but on 69's there are two red and white stripped wires comming from the limit switch that is teminated in a cylindrical molded plug. The trminals are "L" shaped looking at the end. It mates to another similar plug comming out of the firewall.
PaintDaddy,
I have looked at a couple of 71s at a car show and determined that the "extra" red wire is supposed to connect to a red wire coming out of the lower driver side of the wiper motor. My replacement motor does not have this lead. Does yours?
I dont think so ,the car is in storage right now but that sounds like the same problem I was having.