Door "thud"
Thread Starter
Instructor
Joined: Sep 2000
Posts: 125
Likes: 0
From: Houston Texas
Door "thud"
Is there a trick to getting the new car solid "thud" sound back when closing the doors? I know replacing the door glass rubber channeling and greasing the door hinges should somehow help, but is there anything else behind the door panels, like rubber washers or insulation perhaps?
Melting Slicks
Joined: Feb 2004
Posts: 2,435
Likes: 0
From: largo florida
Re: Door "thud" (AGVI)
The door striker is a metal rod with rubber insulation, then a metal sleeve over that. The rubber can deteriorate and fall out. If this happens the door will close and rattle a bit. Cars with metal doors sound tinny if the skins werent undercoated.
Racer
Joined: Apr 2004
Posts: 372
Likes: 0
From: Keizer OR
Re: Door "thud" (BBShark)
Last weekend I adjusted the striker (needs a T55 I think) to get the door panel to be flush with the body. Seems to have made a slight difference in the thud sound. It also made it so that I have to give it a bit more push to get it to close. Not slam it or anything, but it now closes tight against the weatherstripping. The subtle difference in look between flush fitting and off-by-a-bit is worth the door closing effort.
Melting Slicks
Joined: Feb 2002
Posts: 2,298
Likes: 1
From: Sodertalje/Sweden
Re: Door "thud" (skeptic)
My driverside window rattles like poopie when i close the door,so if i`m in the car i usually crank the window down and grab it to close the door...Its on my "to do" list,among alot of stuff :smash: :cheers: :lol: :lol:
3rd Gear
Joined: Mar 2004
Posts: 3
Likes: 0
From: Ventura CA
Re: Door "thud" (82Red)
This is a great question, because it was the first project I undertook on my 73.
consider these possibilites:
1. new weatherstriping.
2. or window anti-rattle bumpers that are inside the door.
3. check the door lock mech. for more anti rattle bumpers on the lock rods.
4. exterior door channel sweeper that can lose their grip.
I say that the door striker is probaly the least probable contributor to a "wimpy" door. If you tune upe the door assembly you will be very satifised when you shut the door at a show, for instance.
:leaving:
consider these possibilites:
1. new weatherstriping.
2. or window anti-rattle bumpers that are inside the door.
3. check the door lock mech. for more anti rattle bumpers on the lock rods.
4. exterior door channel sweeper that can lose their grip.
I say that the door striker is probaly the least probable contributor to a "wimpy" door. If you tune upe the door assembly you will be very satifised when you shut the door at a show, for instance.
:leaving:
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski