Dragvette safety loops installed
Thread Starter
Drifting
Joined: Nov 2002
Posts: 1,951
Likes: 1
From: Shore NJ
Dragvette safety loops installed
I installed the Dragvette safety loops for the half shafts last nite and it was a very easy install. The quality on the loops and hardware is very good, comes with EASY to follow instructions, and should take you about an hour for the complete bolt on application. The hardest part was getting the u joint bearing caps back in the yolk 
. I also ordered the billet caps and will have them this week. Good products well worth the money and piece of mind 
. I also ordered the billet caps and will have them this week. Good products well worth the money and piece of mind
Le Mans Master
Joined: Apr 2000
Posts: 7,562
Likes: 9
From: B'Ville NY
Cruise-In III Veteran
St. Jude Donor '05
Originally Posted by Red_Shift
Anyone else use these saftey loops. I'm considering purchasing some. What does everyone else think of them?
~Bradley
~Bradley
Visit my website for a picture of mine installed
Race Director
Joined: Apr 2000
Posts: 17,676
Likes: 201
From: Who says "Nothing is impossible" ? I've been doing nothing for years.
I think I will be getting them soon to, before I take the plunge for a whole new rear end setup I would like to have a little piece of mind this 406 is one nasty piece.
