Torque spec for bellhousing?
Thread Starter
Senior Member since 1492
Joined: Aug 2000
Posts: 87,922
Likes: 156
From: Just because I'm paranoid doesn't mean people aren't out to get me...
St. Jude Donor '09
Torque spec for bellhousing?
Can't seem to find the torque specs for the bellhousing to block bolts? Can't be much since the bellhousing is aluminum.
Race Director
Joined: Apr 2000
Posts: 17,676
Likes: 201
From: Who says "Nothing is impossible" ? I've been doing nothing for years.
30 ft/lbs, since I always take the motor out without the tranny I can't torque these properly because there is no room for the wrench. I just tighten till it's tight probably much more than 30 ft/lbs come to think of it and never had a problem. 
