Steering sideways.
Thread Starter
Drifting
Joined: Sep 2004
Posts: 1,307
Likes: 1
From: Milford Haven Pembrokeshire
Steering sideways.
Finally found out the problem with my Vette - the drivers side ( and probably the other side ) trailing arm is shot at the chassis end.
Have not taken it apart yet, but it can be seen to move in and out of the chassis mounting.
So, I guess the rubber is gone.
So, here is the question, who to get a pair from considering I am in the UK and they will have to be sent etc.Thanks,
Hugo.
Have not taken it apart yet, but it can be seen to move in and out of the chassis mounting.
So, I guess the rubber is gone.
So, here is the question, who to get a pair from considering I am in the UK and they will have to be sent etc.Thanks,
Hugo.
Race Director
Joined: Sep 2004
Posts: 11,874
Likes: 263
From: Arlington Va Current ride 04 vert, previous vettes: 69 vert, 77 resto mod
i have the HD trailing arms made of 1/4 channel steel regular offset form Ecklers....these are nice.....if i had to do it all over again i would buy these trailing arms fully assembled with all the hubs,bearings, parking brake etc attached...
Thread Starter
Drifting
Joined: Sep 2004
Posts: 1,307
Likes: 1
From: Milford Haven Pembrokeshire
Just found out whats wrong - the garage I paid to fit the new bushes, did not !!!!!!!!!!!!!!
Because they did not have the 12 ?? sided spanner or socket required to fit the UJ clamps.
Its going back in in the morning...........and this time they had better do a good job !!!!!!!!!!
Because they did not have the 12 ?? sided spanner or socket required to fit the UJ clamps.
Its going back in in the morning...........and this time they had better do a good job !!!!!!!!!!
