Quick Vert Question
Thread Starter
Race Director
Joined: Jul 2004
Posts: 11,108
Likes: 0
From: Behind The Redwood Curtain, The State of Jefferson
Quick Vert Question
I noticed the other day that the black part on the outer lid wasn't flush on one side. I know that I had a rattle coming from back there and I know that a bolt wasn't connected to something. I've determined that that bolt is what holds the black part in place. My question is how do I get it back to doing what it's supposed to do?
Race Director
Joined: Jul 2004
Posts: 16,795
Likes: 62
From: Lake Havasu City, AZ
Do you have a digital photo of what is apparently wrong?
I thien could go and take a digital photo of what it is supposed to look like on an '88. But i need to know what you need the photo of...
I thien could go and take a digital photo of what it is supposed to look like on an '88. But i need to know what you need the photo of...
Race Director
Joined: Feb 2003
Posts: 16,475
Likes: 270
From: Kingman AZ
Cruise-In VII Veteran
Cruise-In VIII
St. Jude Donor '06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16
I'm at work right now (obviously screwing off again!). I keep my top down most of the time (87) so I may be getting this confused with my old C3 vert. I think the male pin that is connected to the top's frame has a slot in it. If you take a large flat blade and screw it clockwise then this should bring the corned closer to the lid.
Uh oh - the boss is watching. Wait - I have no boss! Just hope the IT guys aren't watching too close tonight!
Uh oh - the boss is watching. Wait - I have no boss! Just hope the IT guys aren't watching too close tonight!
