Check engine light
Thread Starter
2nd Gear
Joined: Jan 2013
Posts: 2
Likes: 0
Check engine light
Ok, I need to read codes (if there are any) but my CEL is burned out. First off how hard is it to replace the bulb, do I need to tear the dash apart, second could I use a test light to count the flashes instead of the CEL?
Le Mans Master
Joined: Dec 2006
Posts: 5,139
Likes: 482
From: H-Town Texas
What year is the car. There is the paper clip method, of which I'm not an expert, or you can get a reasonably priced code reader at the autoparts store for either OBDI or OBDII.
Replacing the bulb imagine is just a matter of taking the dash front cover off.
Replacing the bulb imagine is just a matter of taking the dash front cover off.
Drifting
Joined: Mar 2013
Posts: 1,952
Likes: 239
From: Venice Cali.
You need to remove the tilt wheel lever and take out the screws on the front panel. There are a few by the door vent . After the dash panel is off just remove the middle panel and the unit itself the bulbs are right there .Piece of cake.
