When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hello, I have a 1994 Corvette base model that I am having issues with a replacement part.
I replaced the drivers side outer lower window molding/sweep (actually I purchased both sides but only installed the drivers side).
The install went smoothly but, upon rolling the window up and down I noticed a strange sticky smear on the out side of the window.
Upon inspection I discovered the inner felt strip is only attached at either end with rivets but the center is glued on.
When the window is rolled down the felt rolls up in the center and visa versa on rolling the window up, leaving a sticky smear of adhesive on the window surface.
I contacted the seller and they sent out a new one but upon inspection it has the same flaw.
The seller refunded my money but now I am searching for a better replacement.
I bought these from a corvette specialty parts and accessories shop. I also contacted a different seller but they couldn't tell me if their part has the felt attached in the same way.
From: Freedom is never more than one generation away from extinction.
St. Jude '03 thru '24
Its been a long time ago I ran into the same problem.
I removed the felt and sticky stuff. Using the "loop" side of some velcro I had laying around rewrapped the guide.
Worked!
Yes that is what I am looking to do, the ones I purchased were from a Corvette specialty parts and accessories shop. I am looking for better quality part than the ones I purchased.
I have called several corvette parts houses and none can tell me how the felt pad is attached.