Code 22, 89 Conv
Thread Starter
Advanced<br><img src="/forums/images/ranks/100-500.gif" border="0">
Joined: Apr 2019
Posts: 87
Likes: 29
From: Livermore, CA
2023 Corvette of the Year Finalist - Unmodified
2022 C4 of the Year Winner - Unmodified
Code 22, 89 Conv
Receivedthe code 22 and replaced the TPS on my 89. Set the voltage at .54 and ran fine for a couple of weeks. Him getting cold 22 again, then attempted to reset the voltage and got no voltage at all. I looked in the shop manual and told me to jump all 3 connections on the TPS. When I did, I got a negative voltage reading. Any ideas or help would be greatly appreciated. Thank you forum!
Last edited by shafe9900; Nov 23, 2020 at 03:24 PM.
Thread Starter
Advanced<br><img src="/forums/images/ranks/100-500.gif" border="0">
Joined: Apr 2019
Posts: 87
Likes: 29
From: Livermore, CA
2023 Corvette of the Year Finalist - Unmodified
2022 C4 of the Year Winner - Unmodified
No reading
Thanks for the reply. I did that and got no reading at all.
I'll try another TPS.
I'll try another TPS.
Team Owner
Joined: Dec 2000
Posts: 90,675
Likes: 304
From: SE NY
Cruise-In II Veteran
Test the two outer wires and you should see +5Vdc, if a negative value reverse DMM leads.
Then, keeping the DMM ground lead on the ground side of the TPS, measure the center electrode voltage.
Also, pull the TPS connector and inspect/clean the connector pins for solidarity. They should be clean and not move in/out when pressed lightly.
Then, keeping the DMM ground lead on the ground side of the TPS, measure the center electrode voltage.
Also, pull the TPS connector and inspect/clean the connector pins for solidarity. They should be clean and not move in/out when pressed lightly.
Thread Starter
Advanced<br><img src="/forums/images/ranks/100-500.gif" border="0">
Joined: Apr 2019
Posts: 87
Likes: 29
From: Livermore, CA
2023 Corvette of the Year Finalist - Unmodified
2022 C4 of the Year Winner - Unmodified
Thanks.
Thank you for the advice! I will check it out. Appreciated the diagram as well.
Thread Starter
Advanced<br><img src="/forums/images/ranks/100-500.gif" border="0">
Joined: Apr 2019
Posts: 87
Likes: 29
From: Livermore, CA
2023 Corvette of the Year Finalist - Unmodified
2022 C4 of the Year Winner - Unmodified
Code 22
Now I'm setting the TPS and I can't get a reading above .31 V
This is beginning to drive me nuts. I did replace my idle air control valve about a month ago.
Suggestions would be greatly appreciated.
Thank you guys out on the forum!
This is beginning to drive me nuts. I did replace my idle air control valve about a month ago.
Suggestions would be greatly appreciated.
Thank you guys out on the forum!
Pro
Joined: Aug 2020
Posts: 647
Likes: 126
From: Liliha Bakery stuffing my face with coco puffs!
Did you set minimum air idle when you change the IAC?
https://www.corvetteforum.com/forums...dle-speed.html
https://www.corvetteforum.com/forums...dle-speed.html
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Thread Starter
Advanced<br><img src="/forums/images/ranks/100-500.gif" border="0">
Joined: Apr 2019
Posts: 87
Likes: 29
From: Livermore, CA
2023 Corvette of the Year Finalist - Unmodified
2022 C4 of the Year Winner - Unmodified
89 Vette
Yes I did..thanks.
Last edited by shafe9900; Nov 29, 2020 at 02:47 PM.